Specifications

Stand
Description Spare part number
Stand 754741-001
The computer stand is secured to a VESA mount inside the computer chassis. You can remove the stand
and install the computer on a wall, monitor arm, or other mounting fixture.
To remove the stand:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Remove the rear cover (see
Rear cover on page 29).
3. Remove the three screws (1) securing the stand to the rear cover, and then remove the stand (2).
NOTE: Save the screws together with the stand in case they are needed in the future.
4. If you need to replace the rear cover with the stand removed (to prepare the computer for VESA
mounting), set the top edge of the rear cover down on the top edge of the computer chassis (1).
Be sure to align the hooks on the underside of the top edge of the rear cover with the top edge of
the computer.
5. Rotate the bottom edge of the rear cover down (2) and press it firmly onto the chassis until it locks
into place.
30 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis