Instruction Manual
Table Of Contents
- HP ProLiant SB460c SAN Gateway Storage Server
- Table of Contents
- About this guide
- 1 Storage management overview
- 2 File server management
- File services features in Windows Storage Server 2003 R2
- File services management
- Volume shadow copies
- Folder and share management
- File Server Resource Manager
- Other Windows disk and data management tools
- Additional information and references for file services
- 3 Print services
- 4 Microsoft Services for Network File System (MSNFS)
- MSNFS Features
- MSNFS use scenarios
- MSNFS components
- Administering MSNFS
- Server for NFS
- User Name Mapping
- Microsoft Services for NFS troubleshooting
- Microsoft Services for NFS command-line tools
- Optimizing Server for NFS performance
- Print services for UNIX
- MSNFS components
- 5 Other network file and print services
- 6 Enterprise storage servers
- 7 Cluster administration
- Cluster overview
- Cluster terms and components
- Cluster concepts
- Cluster planning
- Preparing for cluster installation
- Cluster installation
- Configuring cluster service software
- Cluster groups and resources, including file shares
- Print services in a cluster
- Advanced cluster administration procedures
- Additional information and references for cluster services
- 8 Troubleshooting, servicing, and maintenance
- 9 System recovery
- A Regulatory compliance and safety
- Index
2. On the left side of the window, select Add/Remove Windows Components. The Windows
Components Wizard appears.
3. Select Other Network File and Print Services and click the Details button. The Other Network File
and Print Services window is displayed.
4. Uncheck the Microsoft Services for NFS subcomponent.
5. Click OK, then Next, followed by Finish.
NOTE:
Uninstalling Microsoft Services for NFS removes two primary services:
• Server for NFS
• User Name Mapping
After setting up clustering, should you choose to reinstall Microsoft NFS, follow these steps:
1. Select Start > Settings > Control Panel > Add or Remove Programs. The Add or Remove Programs
window is displayed.
2. On the left side of the window, select Add/Remove Windows Components. The Windows
Components Wizard appears.
3. Select Other Network File and Print Services and click the Details button. The Other Network File
and Print Services window is displayed.
4. Check the Microsoft Services for NFS subcomponent.
5. Click OK, then Next, followed by Finish.
6. After NFS is installed, you can view the details of the Microsoft Services for NFS subcomponent
to see which of its subcomponents were installed. The subcomponents listed below are preinstalled
at the factory. Verify that the Server for NFS and User Name Mapping services have been
reinstalled.
• Microsoft Services for NFS Administration
• RPC External Data Representation
• RPC Port Mapper
• Server for NFS
• Server for NFS Authentication
• User Name Mapping
Checklists for cluster server installation
These checklists assist in preparing for installation. Step-by-step instructions begin after the checklists.
Network requirements
• A unique NetBIOS cluster name
• For each node deployed in the cluster the following static IP addresses are required:
• One for the network adapters on the private network
• One for the network adapters on the public network
• One for the virtual server itself
A single static cluster IP address is required for the entire cluster.
HP ProLiant SB460c SAN Gateway Storage Server 97