Instruction Manual
Table Of Contents
- HP ProLiant SB460c SAN Gateway Storage Server
- Table of Contents
- About this guide
- 1 Storage management overview
- 2 File server management
- File services features in Windows Storage Server 2003 R2
- File services management
- Volume shadow copies
- Folder and share management
- File Server Resource Manager
- Other Windows disk and data management tools
- Additional information and references for file services
- 3 Print services
- 4 Microsoft Services for Network File System (MSNFS)
- MSNFS Features
- MSNFS use scenarios
- MSNFS components
- Administering MSNFS
- Server for NFS
- User Name Mapping
- Microsoft Services for NFS troubleshooting
- Microsoft Services for NFS command-line tools
- Optimizing Server for NFS performance
- Print services for UNIX
- MSNFS components
- 5 Other network file and print services
- 6 Enterprise storage servers
- 7 Cluster administration
- Cluster overview
- Cluster terms and components
- Cluster concepts
- Cluster planning
- Preparing for cluster installation
- Cluster installation
- Configuring cluster service software
- Cluster groups and resources, including file shares
- Print services in a cluster
- Advanced cluster administration procedures
- Additional information and references for cluster services
- 8 Troubleshooting, servicing, and maintenance
- 9 System recovery
- A Regulatory compliance and safety
- Index
Wizards
To support creation and management of iSCSI targets, virtual disks, and snapshots, the iSCSI Software
Target snap-in provides several wizards.
Create iSCSI Target Wizard
This section describes how to create an iSCSI Target using the Create iSCSI Target Wizard.
1. Log on to the storage server using an account with administrative privileges.
2. Open the Microsoft iSCSI Software Target MMC snap-in by clicking Start > Programs >
Administrative Tools > Microsoft iSCSI Software Target.
3. Click the iSCSI Targets node. On the details view (right pane), right-click and select Create iSCSI
Target.
4. Click Next on the Welcome page of the wizard.
5. On the iSCSI Target Identification page, type a name and description for the iSCSI Target and
then click Next.
6. On the iSCSI Initiators Identifiers page, type the iSCSI Qualified Name (IQN) of the iSCSI initiator
requesting access to the iSCSI Target in the IQN identifier field. The IQN is found on the General
tab of the Microsoft iSCSI Initiator interface.
Figure 22 iSCSI Initiators Identifiers page
7. To enter additional identifiers, or if you are using an identifier other than an IQN (DNS domain
name, IP address, or MAC address):
a. Click Advanced.
b. On the Advanced Identifiers page, click Add.
c. Select the identifier type from the Identifier Type list and type the identifier in the Value field.
d. Repeat steps b and c for each identifier you want to add.
e. Click OK.
f. Click OK again to close the Advanced Identifiers page.
HP ProLiant SB460c SAN Gateway Storage Server 85