Specifications

Removal and replacement procedures 44
6.
Remove the DIMM.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
For DIMM configuration information, refer to the HP ProLiant ML370 Generation 4 Server Reference and
Troubleshooting Guide.
To replace the component, reverse the removal procedure.
SCSI backplane
To remove the component:
1. Power down the server (on page 16).
2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).
3. Remove the rack bezel (rack servers only) ("Rack bezel" on page 20).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).
5. Remove the access panel ("Access panel" on page 20).
6. Remove the hard drive cage ("Hard drive cage (SCSI)" on page 25).