Specifications

Removal and replacement procedures 43

Remove the PPM.

NOTE: The appearance of compatible PPMs may vary.

CAUTION: Only install a PPM if the processor is installed. Both the PPM and the processor must be

installed together, otherwise the system does not boot.

IMPORTANT: PPMs do not seat if turned the wrong way.

To replace the component, reverse the removal procedure.

DIMM

To remove the component:

1. Power down the server (on page 16).

2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).

3. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).

4. Remove the access panel ("Access panel" on page 20).

5. Remove the processor air baffle ("Processor air baffle" on page 34).