Specifications

Removal and replacement procedures 38

Squeeze the two tabs securing the assembly from the inside, and slide the power button/LED

assembly through the front of the server.

9. Remove the assembly from the chassis.

To replace the component, reverse the removal procedure.

Diskette drive

To remove the component:

1. Power down the server (on page 16).

2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).

3. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).

4. Remove the access panel ("Access panel" on page 20).

5. Remove all expansion boards ("Expansion board" on page 33).

6. Remove the center wall ("Center wall" on page 35).

7. Remove the power button/LED assembly ("Power button/LED assembly" on page 37).