Specifications

Removal and replacement procedures 34
* x8 PCI Express cards are supported, but will run at x4 speeds.
CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all
AC power cords before removing or installing the expansion boards.
To remove the component:
1. Power down the server (on page 16).
2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).
3. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).
4. Remove the access panel ("Access panel" on page 20).
5. Unlatch the slot release lever.
6. Disconnect any cables attached to the expansion board.
7. Release the retaining clip.
8. Press the slot release lever and swing the slot release lever upward.
9. Lift the expansion board out of the server.
CAUTION: Make a note of board locations. Be sure to install replacements in the same slots.
To replace the component, reverse the removal procedure.
Processor air baffle
To remove the component:
1. Power down the server (on page 16).
2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).
3. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).
4. Remove the access panel ("Access panel" on page 20).
5. Loosen the two thumbscrews that secure the air baffle to the center wall.