Specifications

Removal and replacement procedures 28
Hard drive cage (SAS)
1. Power down the server (on page 16).
2. Unlock and open the front bezel ("Front bezel" on page 19) (tower servers only).
3. Remove the rack bezel (rack servers only) ("Rack bezel" on page 20).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 16).
5. Remove the access panel ("Access panel" on page 20).
6. Disconnect the power cable from the SAS backplane.
NOTE: The center wall is removed for illustration purposes only.
7. Disconnect the SAS-SATA cables from the SAS backplane.