Specifications

Removal and replacement procedures 23
Power supply blank
WARNING: To reduce the risk of electric shock, do not disassemble the power supply or
attempt to repair it. Replace it only with the specified spare part.
CAUTION: Do not attempt to remove and replace a power supply as a hot-plug procedure unless both
bays are populated with power supplies.
To remove the component:
1. Remove the two screws with the T-15 Torx screwdriver.
NOTE: The T-15 Torx screwdriver is clipped to the rear panel of the server.
2. Remove the power supply blank.
To replace the component, reverse the removal procedure.
Hot-plug power supply
WARNING: To reduce the risk of electric shock, do not disassemble the power supply or
attempt to repair it. Replace it only with the specified spare part.
CAUTION: Do not attempt to remove and replace a power supply as a hot-plug procedure unless both
bays are populated with power supplies.
To remove the component:
1. Remove the power cord from the unit to be removed.
2. Use the Torx T-15 screwdriver to remove the shipping screw securing the handle.
NOTE: The T-15 Torx screwdriver is clipped to the rear panel of the server.