Specifications

Removal and replacement procedures 22
4.
Remove the tower hood cover.
To replace the component, reverse the removal procedure.
Rack rails
NOTE: This procedure applies to rack servers only.
To remove the component:
1. Use the Torx T-15 screwdriver to push in the release key.
NOTE: The T-15 Torx screwdriver is clipped to the rear panel of the server.
2. Press the rail against the side of the chassis and slide it to the front of the server to release the rails.
3. Align the four keyholes above the four spools on the side of the chassis and remove the rail.
4. Repeat steps 1 through 3 to remove the other rail.
To replace the component, reverse the removal procedure.