Specifications

Removal and replacement procedures 17
a.
Press the server rail-release latches and slide the server fully into rack.
b. Secure the server by tightening the thumbscrews.
Removing the server from the rack
To remove the server from an HP, telco, or third-party rack:
1. Power down the server (on page 16).
2. Loosen the front panel thumbscrews that secure the server faceplate to the front of the rack.
3. Disconnect the cabling and remove the server from the rack. Reverse the server installation steps in
the documentation that ships with the rack-mounting option.
4. Place the server on a sturdy, level surface.
Feet
NOTE: This procedure applies to tower servers only.
To remove the component:
1. Place the server on its side.