Installation guide

Installing the Rack Server 4-5
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: e-ch04 Installing the Rack Server-J.doc Last Saved On: 7/12/01 1:31 PM
After marking the front and rear of the rack, remove the template from the
rack and prepare the rack for installation.
Installing Cage Nuts in the Rack Frame
After marking the positions for the fasteners in both the front and back of the
rack, insert cage nuts on the inside of the rails at the marked locations. The
cage nuts are included in the hardware kit supplied with the rack.
To install the cage nuts:
1. Position one of the cage nuts on the inside of a vertical rail on the front
of the rack.
2. Compress the sides of the cage nut and insert both lips into the square
cutout on the rail.
NOTE: Use a fitting tool as an aid to help install the cage nuts, if needed.
Figure 4-3. Inserting cage nuts
3. Repeat steps 1 and 2 for a second cage nut.