Installation guide

3-48 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide

Compaq Confidential – Need to Know Required

Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked

Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM

6. Insert the power cord in the redundant power supply.

7. Use the power cord management clip on the power supply to secure the

cord and form a service loop, if needed.

8. Press up on the lower part of the clip to close and lock.

Figure 3-48. Using a management clip to secure the power cord

9. Verify that the power supply LED on the unit is green to indicate that it

is powered up and active.

NOTE: If you remove or replace the primary hot-plug power supply, use the Torx T-15

tool provided with your server to remove the shipping screws from the upper right and left

corners of the power supply unit.

IMPORTANT: For maximum server availability, ensure that the two power supplies are

For additional information about power supply LEDs, see Appendix E, “LED

Indicators and Switches.”