Installation guide

3-44 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
3. Repeat step 2 to install a second hot-plug fan in the redundant fan cage.
Figure 3-42. Installing hot-plug fans in the redundant fan cage
4. Repeat step 2 to install the third hot-plug fan into the available slot in
the fan cage along the center wall.
Figure 3-43. Installing a redundant hot-plug fan into the center wall
5. Install other hardware options as needed.
6. Power up the server. Ensure that internal health LED on the front panel
and the LEDs on all installed fans are green.
NOTE: If the front panel internal health LED is not green after you install hot-plug fans,
see Appendix D, “Troubleshooting,” for possible reasons.
7. Reinstall the access panel.