Installation guide

Installing Hardware Options 3-37
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
9. Reinstall the bezel blank and the CD-ROM drive, if needed.
NOTE: If the second media bay is already populated with an optional drive, store the extra
bezel blank for use at a later time.
10. Install other hardware options as needed or reinstall the access panel.
11. Power up the server.
Installing a Half-Height Media Device
You can install up to two half-height removable devices in the removable
media cage. To install a half-height media device:
1. Power down the server and remove bezel blanks. Follow the procedure
for “Removing Bezel Blanks” in this chapter.
NOTE: It is recommended that you remove all bezel blanks to facilitate drive installation.
2. Remove the Torx T-15 screws from the bezel blank and attach them to
the tape drive as described in steps 2 and 3 in “Installing a
Non-Hot-Plug Hard Drive,” in this chapter.
Figure 3-34. Attaching installation screws to a tape drive