Installation guide

3-34 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
3. Press and hold the sliding media latch to release the blanks while
pushing the blanks from behind to remove
.
NOTE: Removing both bezel blanks is not always necessary, but makes installation and
cabling easier.
Figure 3-29. Removing bezel blanks
4. Store the blanks for reuse at a later time.
Installing a Non-Hot-Plug SCSI Hard Drive
You can install up to two half-height removable devices in the removable
media cage. To install a non-hot-plug SCSI hard drive:
1. Power down the server and remove bezel blanks. Follow the procedure
for “Removing Bezel Blanks” in this chapter.
NOTE: It is recommended that you remove all bezel blanks to facilitate drive installation.