Installation guide

3-32 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
Installing a Hot-Plug SCSI Hard Drive
To install a hot-plug SCSI hard drive:
1. Identify an available slot with the next lowest SCSI ID number. See
“Front Panel Components” in this chapter.
2. Press in on the port-colored release button .
3. Release the locking latch .
4. Insert the hard drive into the available drive bay . Ensure that the drive
seats firmly into the connector on the SCSI backplane.
5. Press the ejector lever in to secure the drive in the drive cage .
Figure 3-28. Installing a hot-plug SCSI hard drive
NOTE: If you backed up your data before replacing a drive, restore your server data from
the backup.
6. Use the hot-plug SCSI hard drive LEDs to identify the status of the
installed drive. For more information about hard drive LEDs, see
“Hot-Plug SCSI Hard Drive LEDs” in Appendix E, “LED Indicators
and Switches.”
7. Resume normal server operations.