Installation guide

3-12 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
Table 3-7
System Board Components
continued
Item Description Item Description
PCI expansion slot 4
(64-bit/33-MHz)
SCSI connector B
PCI expansion slot 5
(64-bit/33-MHz)
SCSI connector A
PCI expansion slot 6
(64-bit/33-MHz)
Fan cable connector
System maintenance
switch (SW1)
PPM slot 2
16-pin Remote
Management connector
Processor socket 2
30-pin Remote
Management connector
Processor socket 1
Power supply signal
header
PPM slot 1
Power supply connector IDE connector
Diskette drive connector DIMM slots
NOTE: Your server is configured for the appropriate switch settings at the factory.
Powering Down the Server
If you are adding hardware options to a new server that is not yet installed in a
rack or work area, install all hardware options before installing and powering
up the server.
If your server is already installed, you must power down the system before
adding non-hot-plug hardware options.
IMPORTANT: Before upgrading components, back up your server data.
To power down the server:
1. Shut down the operating system as directed in your operating system
instructions. This measure enables you to retain system power for use in
performing diagnostic or troubleshooting operations.