Installation guide
3-6 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: d-ch03 Installing Hardware Options-J.doc Last Saved On: 7/13/01 11:36 AM
Locating the Torx T-15 Tool
A Torx T-15 tool is provided with your tower or rack server and is located on
the rear panel. Use this tool to assist with installing options as directed in your
option documentation. Specific uses include:
■ Removing a power supply blank
■ Removing the auxiliary SCSI blank
■ Installing an auxiliary VHDCI SCSI cable
Figure 3-6. Locating the Torx T-15 tool (rack server)
Preparing the Server
WARNING: To reduce the risk of electrical shock or damage to the equipment,
only enter or service specific parts of the server as instructed in the user
documentation.
WARNING: Setting the server Power On/Standby button to the off position
removes power from most areas of the server. This process may take
30 seconds. Portions of the power supply and some internal circuitry remain
active until the AC power cord is disconnected.
To remove power completely, disconnect the power cord. If the server has
multiple power supplies installed, it is necessary to remove all power cords in
order to remove all power from the system.