Installation guide

E-18 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-001 File Name: p-appe LED Indicators and Switches-J.doc Last Saved On: 7/12/01 11:30 AM
System Configuration Settings
It may be necessary at some time to clear and reset system configuration
settings. When the system maintenance switch position 6 is set to the on
position, the system is prepared to erase all system configuration settings from
both CMOS and NVRAM. For additional information about locating the
switch and switch settings, see “System Maintenance Switch” in this appendix.
The default setting for all positions is off.
IMPORTANT: Clearing CMOS and/or (NVRAM) deletes your configuration information. See
Chapter 9, “Server Configuration and Utilities,” for complete instructions on configuring
your server.
To erase all system configuration settings:
1. Power down the server.
2. Remove the access panel.
3. Set the position 6 lever to the on position.
4. Power up the server.
All configuration settings are now erased and all system operations halt.
5. Power down the server.
6. Reset the position 6 lever to the default off position.
7. Power up the server.
8. Press the F9 key to run RBSU and reset all system configuration
settings.
NOTE: For instructions on using RBSU to reset system configuration settings, see
Chapter 9, “Server Configuration and Utilities.”