Installation guide

D-4 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Cynthia Dresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced
Part Number: 203510-001 File Name: o-appd Troubleshooting-J.doc Last Saved On: 7/12/01 11:20 AM
You can enable ASR-2 to restart your server and automatically load the
operating system. Should a critical error occur, ASR-2 logs the error in
the IML and restarts the server.
For more information, refer to the following sections of the Compaq
Servers Troubleshooting Guide:
G “Automatic Server Recovery-2 (ASR-2)”
G “System Short” for other reasons for repeatedly rebooting
6. Restart the server.
IMPORTANT: If the server does not restart, proceed to the following section, “Diagnostic
Steps.”
7. Check the server for the following normal power-up sequence to verify
that your system meets the minimal hardware requirements and is
powered up during normal operations:
a. The front panel power LED turns from standby (amber) to on
(solid green).
b. The fans start up.
8. Check the monitor for the following messages that verify your system
meets the minimal hardware requirements and is powered up during
normal operations:
G Compaq ProLiant logo
G Memory test
G BIOS information
G Copyright information
G Processor initialization
G Multi-initiator configuration
IMPORTANT: Select the multi-initiator configuration utility (CRTL-A) only to support
Compaq storage and clustering options. See Chapter 9, “Server Configuration and
Utilities,” for additional information.
G PXE initialization
G RAID initialization
G SCSI devices
9. The operating system loads to complete the boot process.