Installation guide

A-8 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-001 File Name: l-appa Regulatory Compliance Notices-J.doc Last Saved On: 7/12/01 11:10 AM
Power Cords
The power cord set included in your server meets the requirements for use in
the country where you purchased your server. If you need to use this server in
another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current
marked on the product's electrical ratings label. The voltage and current rating
of the cord should be greater than the voltage and current rating marked on the
product. In addition, the diameter of the wire must be a minimum of 1.00 mm²
or 18AWG, and the length of the cord must be between 6 feet (1.8 m) and
12 feet (3.6 m). If you have questions about the type of power cord to use,
contact your Compaq authorized service provider.
IMPORTANT: Route power cords so that they will not be walked on or pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and the
point where the cords exit from the product.
Mouse Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.