Installation guide

PCI Hot Plug Technology 10-21
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-01 File Name: k-ch10 PCI Hot Plug Technology-J.doc Last Saved On: 7/13/01 11:47 AM
Novell NetWare Operating System Messages
Novell NetWare uses the following list of messages to indicate errors during
PCI Hot Plug operations:
Expansion Board Not Same—The expansion board is not the same as the
expansion board being replaced. The hot-plug replacement cannot continue.
Card Functioning— The expansion board in the slot is currently functioning.
The Add/Replace is ignored.
Driver in Use—The expansion board is currently in use. Do you wish to force
removal?
Driver Loaded—The driver for the expansion board is currently loaded and
must be unloaded manually. Unload the driver and select again.
General Failure—Could not perform the action because of a system failure.
No Hot-Plug Driver—The hot-plug driver is not responding. Check to ensure
the device driver CPQSBD.NLM is loaded.
Remove Not Supt—The Remove action is not supported for the expansion
board/slot.
Switch Open—The slot cannot be initialized because the switch is open. Close
the switch and try Add/Replace again.
Unknown Slot—The Add/Remove was performed on an unknown slot. Try the
command again.
Replace Load Driver—The expansion board is successfully replaced. Please
load the driver at this time.
Refer to the PCI Hot Plug Administration Guide on the Documentation CD
for more information on troubleshooting and error messages.