Installation guide

10-12 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-01 File Name: k-ch10 PCI Hot Plug Technology-J.doc Last Saved On: 7/13/01 11:47 AM
11. Pull the PCI guide clip into a locked position to secure the board in the
slot.
Figure 10-8. Securing the PCI guide clip
12. Connect any required cables to the PCI expansion board.
13. Press the PCI Hot Plug button or use the PCI utility to power up the PCI
Hot Plug slot.
14. Wait until the amber LED is off and the green LED stays on to ensure
proper installation.
15. Install other hardware options as needed or replace the access panel as
described in Chapter 3, “Installing Hardware Options.”
16. If you have a rack-model server, slide the server back into the rack and
secure it as described in Chapter 4, “Installing the Rack Server.”
17. Configure the expansion board using the documentation and software
that ships with the option.
NOTE: For information about using a PCI Hot Plug utility for installations with system
drivers, refer to the software documentation shipped with your server and to
documentation provided by the manufacturer of your operating system.