Installation guide

1-6 Proliant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Proliant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: b-ch01 Server Features-J.doc Last Saved On: 7/12/01 9:40 AM
■
Support for external tape drives and external storage through a
VHDCI SCSI connector on the rear panel
■ Support for hot-plug tape drives and hard drives in six hot-plug SCSI
drive bays
■ Support for non-hot-plug tape drives and hard drives in removable
media bays
ProLiant ML370 Generation 2 servers also support installation of the Smart
Array 5i Controller with:
■ A high-performance Low Voltage Differential SCSI (LVDS) interface
■ Two SCSI ports for up to six internal Ultra2 or Ultra3 SCSI hot-plug
hard drives
■ Support for up to 3 non-hot-plug SCSI drives internally or 14 external
drives without using an expansion slot
■ Support for LVDS devices on both channels
■ Support for external tape drives and external storage through an
auxiliary VHDCI SCSI slot on the rear panel
■ Support for RAID 0, 1, 0+1, and 5
■ 32 MB of total memory for code, transfer buffers, and read-ahead cache
■ Maximum data transfer rates of 160 MB/s on each SCSI bus
Standard Network Interface Controller
The NIC provided with your ProLiant ML370 Generation 2 server is an
Integrated Compaq NC3163 Fast Ethernet NIC with the following features:
■ Dual 10/100 Mb/s data transfer rate integrated on a PCI local bus
■ Auto-sensing LAN capable at either 10 or 100 Mb/s
■ Full-duplex ethernet for two-way transmission
■ Support for PXE technology
■ Support for WOL functionality