Installation guide

8-10 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-001 File Name: i-ch08 Server Cabling-J.doc Last Saved On: 7/12/01 1:46 PM
Power Button/LED Assembly
Compaq ProLiant ML370 Generation 2 servers include a power button/LED
assembly that connects directly to the system board. For instructions on
replacing the power button/LED assembly, refer to the maintenance and
service guide for your server.
PCI Hot Plug Backplane
Compaq ProLiant ML370 Generation 2 servers include a PCI Hot Plug
backplane that provides power to the two PCI Hot plug expansion slots. The
backplane is connected to the system board with a single PCI cable.
For information about replacing the PCI Hot Plug backplane or cable, contact
a Compaq authorized service provider or refer to the maintenance and service
guide for your server.
External Cabling Configurations
The following sections describe cabling configurations for peripheral devices
and external storage devices supported by the ProLiant ML370 Generation 2
server.
SCSI Cabling Guidelines
The external VHDCI SCSI connector is located on the rear panel of the server
as shown in the following figure. This interface enables you to install and
manage external SCSI devices with the system standard Integrated Dual
Channel Ultra3 SCSI controller.
IMPORTANT: Connect either external devices to the external VHDCI SCSI connector or
internal devices to SCSI connector A. Your server does not support both internal and
external devices on the same channel at the same time.