Installation guide

Server Cabling 8-9
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-001 File Name: i-ch08 Server Cabling-J.doc Last Saved On: 7/12/01 1:46 PM
Hot-Plug Fans
Compaq ProLiant ML370 Generation 2 servers ship with three hot-plug fans
installed in the cages attached to the center wall. Fan cables for all fans are
bundled and connect to a single fan connector on the system board so that no
additional cabling is needed.
For instructions on installing hot-plug fans, see Chapter 3, “Installing
Hardware Options,” or refer to the hardware installation poster that ships with
your server and the option label on the inside of the access panel.
Figure 8-9. Cabling hot-plug fans to the fan connector on the system board
Hot-Plug Power Supplies
Compaq ProLiant ML370 Generation 2 servers include a hot-plug power
supply and available power supply bay for 1+1 redundancy. Each power
supply connects directly to the power supply backplane.
For instructions on installing a redundant power supply, see Chapter 3,
“Installing Hardware Options” or refer to the hardware installation poster that
ships with your server. For information about internal power connections or
the power supply backplane, refer the maintenance and service guide for your
server.