Installation guide

Remote Insight Lights-Out Edition Options 7-9
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced Checked by
Devin
Part Number: 203510-001 File Name: h-ch07 Remote Insight Lights-Out Edition-J.doc Last Saved On: 7/13/01 11:50 AM
3. Locate PCI expansion slot 6 and the Remote Management connectors on
the system board.
Figure 7-1. PCI expansion slot 6 and Remote Management connectors
Table 7-1
Remote Management Connectors
Item Description
PCI expansion slot 6
16-pin Remote Management connector
30-pin Remote Management connector
IMPORTANT: Refer to the documentation provided with your option kit to determine
where to use the 16-pin or 30-pin Remote Management connector for your option.
4. Install your Remote Insight board in PCI expansion slot 6 on the system
board. Follow the procedure described in “Expansion Boards” in
Chapter 3, “Installing Hardware Options.”
5. Connect the Remote Insight interface cable provided in your option kit
to the output connector on the Remote Insight expansion board.
NOTE: The Remote Insight interface cable is bi-directional and can be connected at either
end to the expansion board or to the system board connector.