Installation guide

Installing the Tower Server 5-5
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced
Part Number: 203510-001 File Name: f-ch05 Installing the Tower Server-J.doc Last Saved On: 7/12/01 1:33 PM
Power Cord Guidelines
Connect the power cords provided with your server or hot-plug power supply
option into each AC power supply and use the power cord retaining clips to
secure the AC power cords. Leave a service loop for the plug to prevent the
plug from accidentally being disengaged.
NOTE: If needed, use the power cord retaining clip attached to the hot-plug power supply
unit for enhanced cable management. See Chapter 4, “Installing the Rack Server,” for
additional instructions.
Powering Up the Server
Power up the server after the peripheral and power cords are connected to the
server.
WARNING: To reduce the risk of electrical shock or damage to the equipment:
■ Do not disable the power cord grounding plug. The grounding plug is an
important safety feature.
■ Plug the power cord into a grounded (earthed) electrical outlet that is
easily accessible at all times.
■ Unplug the power cord from each power supply to disconnect power to the
equipment.
■ Do not route the power cord where it can be walked on or pinched by
items placed against it. Pay particular attention to the plug, electrical
outlet, and the point where the cord exits from the server.