Installation guide

Installing the Rack Server 4-15
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: e-ch04 Installing the Rack Server-J.doc Last Saved On: 7/12/01 1:31 PM
Securing Cables with the Cable
Management Arm
The cable management arm that ships in the rack kit with your Compaq
ProLiant ML370 Generation 2 server includes hook-and-loop straps that are
used to secure multiple server and peripheral cables to the arm. Using the
guidelines in this section enhances cable management among several servers
in a rack configuration.
Securing Server Cables
Use the cable management straps attached to the cable management arm to
collect and secure external power, network, and peripheral device cables.
Figure 4-14. Sever cables secured to the cable management arm
Securing the Power Cord
After you install power cords into each AC power supply, use the power
supply retaining clips to secure the AC power cords. Form a service loop in
the power cord that is long enough to prevent the plug from being disengaged
accidentally.