Installation guide

Installing the Rack Server 4-11
Compaq Confidential – Need to Know Required
Writer: CDresden Project: Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide Comments: Graphics Replaced - Checked
Part Number: 203510-001 File Name: e-ch04 Installing the Rack Server-J.doc Last Saved On: 7/12/01 1:31 PM
4. Once the server reaches the back of the rack, slide it all the way back out
of the rack until the spring-load rack assembly is fully extended and the
rails lock. This action initializes the rail lock for future use.
5. Press the end tabs on both of the server rails to release the lock .
6. Slide the server all the way back into the rack .
Figure 4-9. Initializing the rail locks
7. Tighten the bezel thumbscrews to secure the server to the front of the
rack.
Figure 4-10. Tightening the thumbscrews