Owner's manual

Hardware options installation 48
3. Slide the power supply into the power supply bay until the release/lock lever clicks, securing the
power supply.
4. Using the retaining clip shipped with the server, secure the power cord to the power supply handle.
Securing the cord will ensure enough slack.
5. Connect the power cord to the power supply.
6. Connect the power cord to the AC power source.
7. Be sure that the power supply and external health LEDs are illuminated green.
Expansion board options
The server supports PCI, PCI-X, and PCI Express expansion boards.
Removing the expansion slot cover
To install the component:
1. Power down the server (on page 17).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 18).
o Extend the server from the rack (on page 17).
3. Remove the access panel (on page 19).