Specifications

Removal and replacement procedures 45
3. Align and install the heatsink with the arrow on the heatsink label pointing to the front of the server.
4. Connect the processor heatsink fan cable to the system board ("System board components" on page
68). When the heatsink is oriented properly, cable length is sufficient for the corresponding
connector.
5. Install the access panel.
6. Lock the bezel.
Processor
CAUTION: Removal of the processor or heatsink renders the thermal layer between the
processor and heatsink useless. Clean the component with the provided alcohol swab, then
add thermal grease.
IMPORTANT: If upgrading processor speed, update the system ROM before installing the
processor.
NOTE: PPM 1 is embedded in the system board.
To remove the component:
1. Power down the server (on page 26).
2. Unlock the bezel (on page 27).
3. Remove the access panel ("Access panel" on page 28).
4. Remove the heatsink ("Heatsink" on page 43).