Specifications

Removal and Replacement Procedures
Pass-Through Board
To remove the pass-through board:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” earlier in
this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” earlier in this chapter.
4. Remove the processor memory boards. Refer to “Processor Memory Boards” earlier in
this chapter.
5. Remove the PCI-X expansion boards. Refer to “PCI-X Expansion Boards” earlier in this
chapter.
6. Remove the SCSI cables. Refer to “SCSI Cables” earlier in this chapter.
7. Remove the front fan cage. Refer to “Front Fan Cage” earlier in this chapter.
8. Loosen the two thumbscrews that secure the pass-through board to the diagnostic display
board and the side chassis wall (1). You may need to use a Torx T-15 screwdriver.
9. Lift the pass-through board straight up and out of the chassis (2).
Figure 2-29: Removing the pass-through board
NOTE: Align the board with connectors on both ends and press simultaneously when installing.
Reverse the steps to replace the pass-through board.
2-34 HP ProLiant DL585 Server Maintenance and Service Guide