Specifications

Removal and Replacement Procedures
Front Bezel
To remove the front bezel:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” earlier in
this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” earlier in this chapter.
4. Using the T-15 Torx tool, remove the six screws on the exterior of the chassis (1) and the
two screws on the interior of the chassis next to the universal media drive bays (2).
Figure 2-22: Removing the exterior and interior chassis screws
2-26 HP ProLiant DL585 Server Maintenance and Service Guide