Specifications

Removal and Replacement Procedures
Processor Power Module (PPM)
To remove a processor power module:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Extend the server from the rack. Refer to “Extending the Server from the Rack” earlier in
this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” earlier in this chapter.
4. Remove the processor memory board. Refer to “Processor Memory Boards” earlier in
this chapter.
5. Remove the PPM from the processor memory board.
Figure 2-10: Removing a PPM
Reverse the steps to install a PPM.
HP ProLiant DL585 Server Maintenance and Service Guide 2-13