Manual

Hardware options installation 35
8.
Connect the Mini-SAS cable from the storage controller to the drive backplane.
9. Install the PCI riser cage (on page 22).
10. Install the processor air baffle (on page 20).
11. Install the access panel (on page 19).
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (on page 16).
Installing the 800 mm Mini-SAS cable
1. Power down the server (on page 16).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 17).
o Remove the server from the rack (on page 16).
4. Remove the access panel (on page 19).
5. Remove the processor air baffle (on page 20).
6. Install an optional P822 Smart Array controller.