Manual

Hardware options installation 34
5.
Install the drive.
6. Install the drive into the drive bay.
7. Power up the server (on page 16).
8. Determine the status of the drive from the drive LED definitions (on page 12).
Mini-SAS cable option
The server supports 700 mm and 800 mm Mini-SAS cable options. These cable options are used for
connecting the optional Smart Array controllers installed in a full–height PCI slot.
Installing the 700 mm Mini-SAS cable
1. Power down the server (on page 16).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 17).
o Remove the server from the rack (on page 16).
4. Remove the access panel (on page 19).
5. Remove the processor air baffle (on page 20).
6. Remove the PCI riser cage (on page 21).
7. Install the storage controller ("Installing a storage controller" on page 38).