Owner manual
Table Of Contents
- HP ProLiant BL495c Generation 5 Server Blade User Guide
- Notice
- Contents
- Component identification
- Operations
- Setup
- Hardware options installation
- Cabling
- Software and configuration utilities
- Server blade deployment tools
- Configuration tools
- Management tools
- Automatic Server Recovery
- ROMPaq utility
- iLO 2 technology
- Erase Utility
- StorageWorks library and tape tools
- HP Systems Insight Manager
- Management Agents
- HP ProLiant Essentials Virtualization Management Software
- HP ProLiant Essentials Vulnerability and Patch Management Pack
- HP Insight Server Migration software for ProLiant
- HP ProLiant Essentials Performance Management Pack
- HP Insight Control Environment Suites
- HP Insight Control Linux Edition
- Redundant ROM support
- USB support and functionality
- Diagnostic tools
- Remote support and analysis tools
- Keeping the system current
- Troubleshooting
- Battery replacement
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Declaration of conformity for products marked with the FCC logo, United States only
- Modifications
- Cables
- Canadian notice (Avis Canadien)
- European Union regulatory notice
- Disposal of waste equipment by users in private households in private households in the European Union
- Japanese notice
- BSMI notice
- Korean notice
- Laser compliance
- Battery replacement notice
- Taiwan battery recycling notice
- Electrostatic discharge
- Specifications
- Technical support
- Acronyms and abbreviations
- Index
13.
Install the heatsink. Insert both screws, and then alternate tightening until the heatsink is seated
properly.
14. Install the access panel (on page 13).
15. Install the server blade ("Installing a server blade" on page 17).
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The
card type determines where it can be installed in the server blade.
• Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
• Install Type II mezzanine cards only on mezzanine 2 connector.
Optional mezzanine cards enable network connectivity and provide Fibre Channel support. For
mezzanine card locations, see the
system board components (on page 8).
For mezzanine card signal mapping, see the
HP ProLiant BL495c Generation 5 Server Blade Installation
Instructions
that ship with this server blade.
To install the component:
1. Power down the server blade (on page 11).
2. Remove the server blade (on page 12).
3. Remove the access panel (on page 12).
Hardware options installation 28