Owner manual
Table Of Contents
- HP ProLiant BL495c Generation 5 Server Blade User Guide
- Notice
- Contents
- Component identification
- Operations
- Setup
- Hardware options installation
- Cabling
- Software and configuration utilities
- Server blade deployment tools
- Configuration tools
- Management tools
- Automatic Server Recovery
- ROMPaq utility
- iLO 2 technology
- Erase Utility
- StorageWorks library and tape tools
- HP Systems Insight Manager
- Management Agents
- HP ProLiant Essentials Virtualization Management Software
- HP ProLiant Essentials Vulnerability and Patch Management Pack
- HP Insight Server Migration software for ProLiant
- HP ProLiant Essentials Performance Management Pack
- HP Insight Control Environment Suites
- HP Insight Control Linux Edition
- Redundant ROM support
- USB support and functionality
- Diagnostic tools
- Remote support and analysis tools
- Keeping the system current
- Troubleshooting
- Battery replacement
- Regulatory compliance notices
- Regulatory compliance identification numbers
- Federal Communications Commission notice
- Declaration of conformity for products marked with the FCC logo, United States only
- Modifications
- Cables
- Canadian notice (Avis Canadien)
- European Union regulatory notice
- Disposal of waste equipment by users in private households in private households in the European Union
- Japanese notice
- BSMI notice
- Korean notice
- Laser compliance
- Battery replacement notice
- Taiwan battery recycling notice
- Electrostatic discharge
- Specifications
- Technical support
- Acronyms and abbreviations
- Index
For hard drive connector locations, see "System board components (on page 8)."
6. Connect and route the cables.
7. Install the access panel (on page 13).
8. Install the server blade ("Installing a server blade" on page 17).
Memory option
You can expand server memory by installing PC2-5300 Registered DDR2 SDRAM DIMMs. The server
supports up to 128 GB of memory using 16 8-GB DIMMs (eight DIMMs per processor).
NOTE: The Advanced Memory Protection option in RBSU provides additional memory
protection beyond Advanced ECC. By default, the server is set to
Advanced ECC Support. For
more information, refer to "
HP ROM-Based Setup Utility (on page 40)."
For DIMM slot locations and bank assignments, see "System board components (on page 8)."
Hardware options installation 20