Instruction Manual

Hardware options installation 37
CAUTION: Any attempt to remove an installed TPM from the system board breaks or
disfigures the TPM security rivet. Upon locating a broken or disfigured rivet on an installed
TPM, administrators should consider the system compromised and take appropriate measures
to ensure the integrity of the system data.
5. Install the TPM board. Press down on the connector to seat the board ("System board components"
on page 8).
6. Install the TPM security rivet by pressing the rivet firmly into the system board.
7. Install the access panel (on page 15).
8. Install the server blade ("Installing a server blade" on page 18).
9. Power up the server blade (on page 13).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of
system integrity.