Specifications

HP ProDesk 400 G2 and 480 G2 models:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector
on the system board labeled SATA0.
●
Connect a secondary hard drive to the light blue SATA connector on the system board labeled SATA1.
●
Connect an optical drive to one of the white SATA connectors on the system board labeled SATA4 or
SATA5.
HP ProDesk 490 G2 models:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector
on the system board labeled SATA0.
●
Connect secondary hard drives and optical drives to one of the light blue SATA connectors on the
system board (labeled SATA1 and SATA4).
HP has provided four extra 6-32 hard drive mounting screws installed on the front of the chassis behind the
bezel (1). The mounting screws are required for 3.5-inch and 2.5-inch hard drives installed in the hard drive
bays. If you are replacing a drive, remove the mounting screws from the old drive and install them in the new
drive.
CAUTION: To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and
unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as
monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the
package “Fragile: Handle With Care.”
Drives 37