- HP All in One Printer User Manual

2Ć2 Site Planning and Requirements
C3187Ć90000
Power Requirements
HP C3180A and C3181A DesignJet 200 and HP C3187A and C3188A DesignJet 220 plotters
have selfĆadjusting power supplies and do not require a voltage selector or switch settings
prior to use. The table below lists the power requirements for the plotters.
Power Requirements
Source Voltage Requirements:
Frequency:
Voltage Max current (rms)
100 V ac 1.4 A
120 V ac 1.2 A
220 V ac 650 mA
240 V ac 600 mA
47-53 Hz and 57-63 Hz
Consumption: 140 watts maximum
WARNING
  # !   ! "    "
  !  !  % 
    !$ $ !      
$ !
The power cord supplied with the plotter should meet the plug requirements for the
geographical area. However, different power cords (international options) are available.
(Cable part numbers ' chapter 10.)
Choosing an Interface Cable
(Instructions ' User's Guide, chapter 1, w Choosing an interface cable.)
 &&   A short cable (less than 15 meters or 50 feet) is recommended
for the RSĆ232ĆC interface. A longer cable is permissible, provided the load capacitance does
not exceed 2500 picofarads.
 &    Use a short cable (less than 2 meters or 6.6 feet)
for the parallel interface.
(Interface descriptions ' Service Manual, chapter 5, w Input/Output Interfaces.)
(Pin specifications ' User's Guide, chapter 6, w Interface specifications.)
(Cable part numbers ' Service Manual, chapter 10.)