Reference Guide

MIB descriptions
COLUBRIS-LICENSE-MIB
3-57
 coVirtualApAuthenMode
.1.3.6.1.4.1.8744.5.11.1.1.1.1.7 read-only
Identifies if user authentication is performed locally or via an external authentication
server.
 coVirtualApAuthenProfileIndex
.1.3.6.1.4.1.8744.5.11.1.1.1.1.8 read-only
Specifies the authentication server profile to use for user authentication. This parameter
only applies when the coVirtualApSecurity is set to ’wpa’ or ’ieee802dot1x’ and
coVirtualApAuthenMode is set to ’profile’ or ’localAndProfile’. When set to zero, no
authentication server profile is selected or on a AP it could represent a pre-configured
authentication profile.
 coVirtualApUserAccountingEnabled
.1.3.6.1.4.1.8744.5.11.1.1.1.1.9 read-only
Indicates if accounting information is generated by the device and sent to the
authentication server for connected users. Accounting information will be generated only
if a valid authentication server profile is configured for the
coVirtualApAccountingProfileIndex attribute.
 coVirtualApUserAccountingProfileIndex
.1.3.6.1.4.1.8744.5.11.1.1.1.1.10 read-only
Identifies the authentication server profile to be used for accounting information. The
special value Zero indicates that no accounting profile is selected.
 coVirtualApDefaultUserRateLimitationEnabled
.1.3.6.1.4.1.8744.5.11.1.1.1.1.11 read-only
Indicates if the default user rate limitation is enabled.
 coVirtualApDefaultUserMaxTransmitRate
.1.3.6.1.4.1.8744.5.11.1.1.1.1.12 read-only
Identifies the default user maximum transmit rate.
 coVirtualApDefaultUserMaxReceiveRate
.1.3.6.1.4.1.8744.5.11.1.1.1.1.13 read-only
Identifies the default user maximum receive rate.
 coVirtualApDefaultUserBandwidthLevel
.1.3.6.1.4.1.8744.5.11.1.1.1.1.14 read-only
Identifies the default user bandwidth level.
 coVirtualApOperState
.1.3.6.1.4.1.8744.5.11.1.1.1.1.15 read-write
Activate/Deactivate the VSC on the radio.
COLUBRIS-LICENSE-MIB
This MIB is used to view the list of licenses installed in a HP device.