Reference Guide

MIB descriptions
COLUBRIS-PUBLIC-ACCESS-MIB
3-40
 publicAccessUserMaxReceiveRate
.1.3.6.1.4.1.8744.5.1.1.3.6.1.31 read-only
Specifies the maximum receive rate for the user.
 publicAccessUserBandwidthControlLevel
.1.3.6.1.4.1.8744.5.1.1.3.6.1.32 read-only
Specifies the user’s bandwidth control level.
 publicAccessUserNASPort
.1.3.6.1.4.1.8744.5.1.1.3.6.1.33 read-only
Specifies the NAS-Port value assigned to the user.
publicAccessUsersLoggedInTrapEnabled
.1.3.6.1.4.1.8744.5.1.1.3.7 read-write
When set to enable, the publicAccessUsersLoggedInTrap is generated.
publicAccessUsersLoggedInTrapInterval
.1.3.6.1.4.1.8744.5.1.1.3.8 read-write
Interval between publicAccessUsersLoggedInTrap traps. Setting this to 0 will disable periodic
sending of these traps.
publicAccessNASPortCount
.1.3.6.1.4.1.8744.5.1.1.4.1 read-only
Indicates the number of NAS-Port supported.
publicAccessNASPortTable
.1.3.6.1.4.1.8744.5.1.1.4.2 not-accessible
A table containing specific information for NAS-Port by the Access Controller. In tabular form
to allow multiple instances on an agent.
 publicAccessNASPortEntry
.1.3.6.1.4.1.8744.5.1.1.4.2.1 not-accessible
Information about a particular NAS-Port by Access Controller.
publicAccessNASPortIndex - Uniquely identifies a NAS-Port in the table.
 publicAccessNASPortIndex
.1.3.6.1.4.1.8744.5.1.1.4.2.1.1 not-accessible
Index of a NAS-Port in the publicAccessNASPortTable.
 publicAccessNASPortUserName
.1.3.6.1.4.1.8744.5.1.1.4.2.1.2 read-only
Indicates the user’s name currently authenticated by the Access Controller on this NAS-
Port.
COLUBRIS-PUBLIC-ACCESS-MIB Traps
publicAccessStatusChangedTrap
.1.3.6.1.4.1.8744.5.1.2.0.1
This notification is sent whenever the authentication system status changes (up or down).
Parameters: publicAccessStatus,publicAccessStatusChangedCause.