Reference Guide

MIB examples
Installing the MIBs
2-3
6. Specify the following and then select OK.
 Variable Name: MIBDIRS
 Variable Value: c:\net-snmp\usr\mibs
7. In the System variables box, select Path and then select Edit.
8. Append the following to the end of the existing path and select OK.
;c:\net-snmp\usr\bin;
9. Select OK.
Installing the MIBs
The MIBs that you use must match the software version that is installed on your hardware.
Using older MIBs may result in some SNMP MIB objects not being found.
An MSM MIBs zip file is available at www.hp.com/networking/mibs. Look for the file
corresponding to your MSM software version.
Note The same MIB package applies to ALL products running the SAME firmware.
Use the following steps to install the MIBs.
1. Download the appropriate MIB file.
2. Extract the files from the MIBs zip file to the c:\net-snmp\usr\mibs folder, which already
has some standard MIBs in it. Verify that the MIBs were added to this folder.
SNMP examples
This section contains examples to shown you how to use the Net-snmp tool to “browse” the
MIBs and “walk”, “get,” or “set” values.