Reference Guide

MIB descriptions
COLUBRIS-TOOLS-MIB
3-136
traceNumberOfPackets
.1.3.6.1.4.1.8744.5.12.1.1.5 read-write
Specifies the maximum number of packets (IP datagrams) the trace should capture. Once this
limit is reached, the trace automatically stops.
tracePacketSize
.1.3.6.1.4.1.8744.5.12.1.1.6 read-write
Specifies the maximum number of bytes to capture for each packet. The remaining data is
discarded.
traceCaptureFilter
.1.3.6.1.4.1.8744.5.12.1.1.7 read-write
Specifies the packet filter to use to capture data. The filter expression has the same format and
behavior as the expression parameter used by the well-known TCPDUMP command.
traceCaptureStatus
.1.3.6.1.4.1.8744.5.12.1.1.8 read-write
IP Trace tool action trigger.
’stop’: Stops the trace tool from functioning. If any capture was previously started it will end up.
if no capture was started, ’stop’ has no effect.
’start’: Starts to capture the packets following the criteria specified in the management tool and
in this MIB.
traceNotificationEnabled
.1.3.6.1.4.1.8744.5.12.1.1.9 read-write
Specifies if IP trace notifications are generated.
COLUBRIS-TOOLS-MIB Traps
traceStatusNotification
.1.3.6.1.4.1.8744.5.12.2.0.1
Sent when the user triggers the IP Trace tool either by starting a new trace or stopping an
existing session.
Parameters: traceCaptureStatus.