Reference Guide

MIB descriptions
COLUBRIS-802DOT11-MIB
3-125
 coDot11FrequencyBandsSupported
.1.3.6.1.4.1.8744.5.4.3.9.1.3 read-only
The capability of the OFDM PHY implementation to operate in the three U-NII bands.
Coded as an integer value of a three 1 bit fields as follow:
bit 0 - Capable of operating in the lower (5.15-5.25 GHz) U-NII band.
bit 1 - Capable of operating in the middle (5.25-5.35 GHz) U-NII band.
bit 2 - Capable of operating in the middle (5.725-5.825 GHz) U-NII band.
For example, for an implementation capable of operating in the lower and middle bands,
this object would take the value 3.
coDot11MinimumSNRLevel
.1.3.6.1.4.1.8744.5.4.3.10 read-write
An SNR level notification is generated when the average SNR level is below this attribute. Not
supported on the M111.
coDot11SNRLevelNotificationEnabled
.1.3.6.1.4.1.8744.5.4.3.11 read-write
This attribute, when true, enables the generation of SNR level notifications. Not supported on
the M111.
coDot11SNRLevelNotificationInterval
.1.3.6.1.4.1.8744.5.4.3.12 read-write
Interval in minutes between SNR Level notifications. Not supported on the M111.
coDot11CountryCode
.1.3.6.1.4.1.8744.5.4.3.13 read-only
The radios are running accordingly to the regulations of this country.
coDot11PhyHTTable
.1.3.6.1.4.1.8744.5.4.3.14 not-accessible
Entry of attributes for coDot11PhyHTEntry. This table only apply when the PHY type is HT.
 coDot11PhyHTEntry
.1.3.6.1.4.1.8744.5.4.3.14.1 not-accessible
An entry in the coDot11PhyHTEntry Table.
ifIndex - Each 802.11 interface is represented by an ifEntry. Interface tables in this MIB
module are indexed by ifIndex.
 coDot11FortyMHzOperationImplemented
.1.3.6.1.4.1.8744.5.4.3.14.1.1 read-only
This attribute, when TRUE, indicates that 40 MHz Operation is implemented.
 coDot11FortyMHzOperationEnabled
.1.3.6.1.4.1.8744.5.4.3.14.1.2 read-only
This attribute, when TRUE, indicates that 40 MHz Operation is enabled.
 coDot11CurrentPrimaryChannel
.1.3.6.1.4.1.8744.5.4.3.14.1.3 read-only
This attribute indicates the operating channel. If 20/40 MHz Mode is currently in use then
this attribute indicates the primary channel.