Reference Guide

MIB descriptions
COLUBRIS-802DOT11-MIB
3-108
 coDot11ScanIndex
.1.3.6.1.4.1.8744.5.4.1.7.1.1 not-accessible
The auxiliary variable used to identify instances of AP in the scan table.
 coDot11ScanMacAddress
.1.3.6.1.4.1.8744.5.4.1.7.1.2 read-only
The wireless MAC address of the remote device.
 coDot11ScanChannel
.1.3.6.1.4.1.8744.5.4.1.7.1.3 read-only
The operating frequency channel of the remote device.
 coDot11ScanSSID
.1.3.6.1.4.1.8744.5.4.1.7.1.4 read-only
The Service Set ID broadcast by the remote device.
 coDot11ScanSignalLevel
.1.3.6.1.4.1.8744.5.4.1.7.1.5 read-only
Strength of the wireless signal.
 coDot11ScanNoiseLevel
.1.3.6.1.4.1.8744.5.4.1.7.1.6 read-only
Level of local background noise.
 coDot11ScanSNR
.1.3.6.1.4.1.8744.5.4.1.7.1.7 read-only
Relative strength of the signal level compared to the noise level.
 coDot11ScanStatus
.1.3.6.1.4.1.8744.5.4.1.7.1.8 read-only
The status of the scanned device. ’unknown’: The device could not determine the status of
the scanned AP. ’authorized’: The AP is part of the authorized list of APs. ’unauthorized’:
The AP is not part of the authorized list of APs.
 coDot11ScanPHYType
.1.3.6.1.4.1.8744.5.4.1.7.1.9 read-only
Radio type used by the device.
 coDot11ScanInactivityTime
.1.3.6.1.4.1.8744.5.4.1.7.1.10 read-only
Elapsed time since the last beacon was seen for this device.
 coDot11ScanNetworkType
.1.3.6.1.4.1.8744.5.4.1.7.1.11 read-only
Network type used by the device.
 coDot11ScanSecurity
.1.3.6.1.4.1.8744.5.4.1.7.1.12 read-only
Indicates the WPA/Encryption type used by the wireless station.