Reference Guide

MIB descriptions
COLUBRIS-802DOT11-MIB
3-107
 coDot11WDSPortMacAddress
.1.3.6.1.4.1.8744.5.4.1.6.1.2 read-write
MAC address of the remote device on the other side of the local mesh link.
 coDot11WDSPortCurrentRate
.1.3.6.1.4.1.8744.5.4.1.6.1.3 read-only
Current rate of the local mesh link.
 coDot11WDSPortSNRLevel
.1.3.6.1.4.1.8744.5.4.1.6.1.4 read-only
Relative strength of the signal level compared to the noise level.
 coDot11WDSPortTxPackets
.1.3.6.1.4.1.8744.5.4.1.6.1.5 read-only
Number of packets transmitted on this local mesh link.
 coDot11WDSPortTxDropped
.1.3.6.1.4.1.8744.5.4.1.6.1.6 read-only
Number of packets that could not be transmitted on this local mesh link.
 coDot11WDSPortTxErrors
.1.3.6.1.4.1.8744.5.4.1.6.1.7 read-only
Number of packets that could not be sent due to the following reasons: Rx retry limit
exceeded or Tx discarded because of wrong SA.
 coDot11WDSPortRxPackets
.1.3.6.1.4.1.8744.5.4.1.6.1.8 read-only
Number of packets received on this local mesh link.
 coDot11WDSPortRxDropped
.1.3.6.1.4.1.8744.5.4.1.6.1.9 read-only
Number of packets that were dropped on this local mesh link due to a lack of resources.
 coDot11WDSPortRxErrors
.1.3.6.1.4.1.8744.5.4.1.6.1.10 read-only
Number of packets that could not be received due to the following reasons: Rx discards
WEP excluded, Rx discards WEP ICV error, Rx MSG in bad MSG fragments, Rx MSG in
MSG fragments Rx WEP undecryptable, Rx FCS errors.
coDot11ScanTable
.1.3.6.1.4.1.8744.5.4.1.7 not-accessible
Conceptual table for the AP scanning results. In tabular form to allow multiple instances on an
agent. This table is not supported on the WCB-200.
 coDot11ScanEntry
.1.3.6.1.4.1.8744.5.4.1.7.1 not-accessible
An Entry (conceptual row) in the AP scan Table.
ifIndex - Each 802.11 interface is represented by an ifEntry. Interface tables in this MIB
module are indexed by ifIndex.
coDot11ScanIndex - Uniquely identify an AP in the scan Table.